The Atlona AT-HDVS-150-TX-WP features an HDMI input plus VGA input with 3.5mm audio connector and a 2-gang wall plate. Designed as a remote input device for the AT-UHD-CLSO-824 matrix switcher, the AT-HDVS-150-TX-WP combines the benefits of a switcher with built-in auto-switching and the advantages of long-distance HDBaseT signal extension over a single cable. HDMI signals up to 4K/UHD @ 60Hz with embedded audio, VGA input signals up to 1920x1200 video, and control signals can be extended up to 230 feet (70 meters). The switcher enables auto display on/off, auto-switching, along with other features. The switcher receives power from the AT-UHD-CLSO-824 using Power over Ethernet. The AT-HDVS-150-TX fits inside any 40mm deep 2-gang electrical box or mud ring and is ideal for long distance transmission and display control in corporate or educational settings using analog and digital sources.

The Atlona AT-HDVS-150-TX-WP switcher expands the input capabilities of the AT-UHD-CLSO-824. Each remote switcher provides input access for up to two devices with controls for input selection and can control the power state of a display or projector when used with a third party control system. The HDVS series is designed to smooth the transition from analog to digital displays, allowing advanced HDMI display devices to be used with legacy VGA sources. The series also adds the simplicity and performance of HDBaseT technology to eliminate multiple cable runs and signal degradation that can occur with long transmission lines. Cost-effective and easy-to-terminate category cable provides additional integrator benefits.

The AT-HDVS-150-TX-WP, when used in combination with the AT-HDVS-150-RX receiver, allows automatic display control using RS-232 signals. When integrated with a display, the AT-HDVS-150-RX forces the display to power on automatically when a laptop is connected to the AT-HDVS-150-TX-WP. At the end of the presentation, when the presenter disconnects the laptop from the transmitter, the AT-HDVS-150-RX forces the display to power off. Ease of presenter interaction with the system and the savings incurred by auto-display shutdown provide a significant return on investment. Many displays including projectors, commercial flat panel displays, and some consumer displays can be controlled using the RS-232 signal directly from the switcher. The switcher is able to send commands using RS-232 for automatic display control to compatible displays. Automatic input selection on the AT-HDVS-150-TX-WP uses the 5 volt, hot plug signal in order to detect and automatically switch to the proper input.

The AT-HDVS-150-TX-WP is great for education environments, the wall plate switcher is placed in furniture or is wall-mounted for use with a laptop and document camera. Auto-switching technology selects the active source input and routes the signal via HDBaseT to the switcher downstream. The AT-HDVS-150-TX-WP is also well suited for corporate environments, wall plate switcher is wall-mounted near a boardroom conference table or furniture-mounted to allow presenters to easily connect to the system. When integrated with a control system, commands can be sent to activate a display from the front panel of the switcher.

Features:

• Shallow, 1.5" (40 mm) deep wall plate simplifies integration with recessed RJ-45 connector
• Attractive alternative to table-top boxes for placement near presenter’s station
• 2x1 HDBaseT™ switcher
• HDMI input plus VGA input with 3.5mm audio connector
• Long distance HDMI extension
• Uses easy-to-integrate category cable for low-cost, reliable system installation
• Automatic display control
• Automatic input selection using 5 volt detection
• Front panel display on/off control
• Simple manual control allows presenter to maintain control of AV system
• Allows input control only from 3rd party switcher